Architectural terms II
Mar 03, 2023
8. deformation joint: deformation joint is the general name of expansion joint (temperature joint), settlement joint and seismic joint. (1) Expansion joint refers to the continuous opening of the joint foundation (affected by the temperature difference) in order to overcome the climate temperature change of the building component (thermal expansion and cold contraction). The settlement joint is a vertical joint set up to overcome the building structure due to the uneven settlement of the foundation caused by the damage of the building, from the foundation to the superstructure are completely separated. (3) Aseismatic joint refers to the vertical structural joint set up according to the aseismatic requirements to avoid building damage.
9. parapet: refers to the low wall outside the roof of the building, in addition to the role of guardrail, but also to the plane waterproof layer turned over to close, to avoid water seepage or roof rainwater. According to the building technical rules, the parapet is regarded as the role of railings, such as the building in the height of more than 10 floors shall not be less than 1.2m, in order to avoid the industry deliberately raise the parapet, convenient later construction illegal, also stipulated that the height shall not exceed 1.5m.
10. anti beam: anti beam is just a need, because of some reasons (such as the height is not enough, the bottom surface of the beam needs to be flat, and the upper part of the beam can be turned over, etc.), and the high part of the beam to the upper part of the floor (the general beam is flat with the floor) or the surface of the raft foundation needs to be flat and the beam is below the plate.
11. the water mouth: is a kind of rain mouth, the construction of the so-called rain mouth is the water mouth. It is a device that collects and guides roof rainwater into the drain pipe in the organized drainage mode of roof or floor. There are straight-line and side-row spouts.
(1) Drainage spout: refers to the building with a gutter on the roof, and the spout is directly discharged from the gutter into the drainage bucket.
Side row spout: refers to the roof without gutter, there is a parapet, the spout needs to be discharged from the inside of the parapet wall, and then turn 90 degrees into the spout bucket.






